Wedge wire centrifuge baskets
Slotted baskets for filtering centrifuges, providing a liquid passage while retaining the required solids during rotation. Geometry, mounting, slot arrangement and mechanical requirements must be matched to the centrifuge and its process duty.

Operating principle and configuration
Rotation drives liquid toward and through the screening surface while the retained solids form the separated product. Feed rate, particle distribution, solids concentration and discharge conditions influence the result. The basket is a machine component; its slot alone does not determine final moisture or solids recovery.
Baskets may use cylindrical or conical geometry according to the host design. The conical basket pictured is one example. End diameters, height, cone geometry, mounting flange, concentricity and running clearances require the actual equipment drawing. A rotating replacement also needs the specified structural, runout and balance checks.
Main technical specifications for selection
| Machine identification | Centrifuge type and model, part number, basket drawing, assembly drawing and permitted operating conditions. |
|---|---|
| Basket geometry | End diameters, height, cone angle where applicable, active surface, unslotted areas and drawing tolerances. |
| Mounting interface | Flange dimensions, bolt pattern, seats, locating features and connection to the rotating assembly. |
| Slot and support construction | Opening and tolerance, wire profile and orientation, supporting members and required working face. |
| Feed and separation target | Particle sizes, flow, solids loading, target moisture and permitted solids loss with the filtrate. |
| Rotation and mechanical duty | Operating and permitted maximum speed, loading and discharge conditions, specified runout and balance acceptance requirements. |
| Material and wear | Fluid chemistry, temperature, corrosion, abrasion, cleaning chemicals and existing localized wear patterns. |
| Inspection and scope | Basket assembly or screening section, material documents, dimensional and slot inspection, weld checks and agreed mechanical verification. |
Technical arrangement

Installation, inspection and cleaning
- Check the replacement against the approved machine and assembly drawings, including mounting and adjacent moving-part clearances.
- Install and commission using the centrifuge procedure. Confirm the specified inspection and balance requirements before returning the assembly to service.
- During planned inspection, look for enlarged slots, cracks, deformation, loose connections and uneven deposits or wear.
- Record vibration changes, product moisture, filtrate solids and operating conditions. Investigate abnormalities using the host equipment’s operating and maintenance instructions.
Related filter equipment
Request a technical review
Send the basket and assembly drawings, centrifuge identification, operating speed and load, slot details, feed data and photos of both ends, mounting and wear. Identify missing dimensions or inspection requirements before finalizing the replacement specification.