Industrial filtration and screening

Wedge wire resin traps

A protective screening element or assembly in the outlet line of a media treatment unit. Its duty is to intercept the specified escaped resin or media particles before they reach downstream equipment.

Cylindrical wedge wire resin-trap element

Operating principle and configuration

Liquid passes through a slotted element fitted inside a housing or line assembly. The specified particles are retained on the working surface. This outlet protection has a different duty from the internal laterals or nozzles that normally hold the bed in the upstream vessel.

Specify whether the order is for a replacement screen element or a complete resin-trap assembly. An element has its own mounting, sealing and differential-pressure requirements; the housing, line connections and design pressure require separate definition.

Main technical specifications for selection

Media to be retainedResin or other media type, size distribution and expected broken beads or fines; state the retention objective.
Fluid and flowNormal and maximum flow, viscosity, temperature, fluid chemistry and cleaning chemicals.
Slot selectionNominal opening and tolerance matched to the target particles. A slot value alone does not define the behaviour of all broken or irregular particles.
Element geometryOverall and active length, diameter, flow direction, wire and support profiles and any reinforcement.
Mounting and sealingElement seat, end connections, seal material, positive retention and removal clearance to prevent bypass.
Pressure conditionsHousing operating and design conditions, plus clean and fouled-element differential pressure and any permitted reverse cleaning.
MonitoringLocations for upstream and downstream pressure measurement and the agreed alarm, isolation or shutdown response.
Scope and inspectionReplacement element or full assembly; connection standard, access, quantity, material identification and agreed dimensional and weld checks.

Technical arrangement

Conceptual cylindrical screen-element geometry. This is not a pressure-housing drawing or a fixed resin-trap flow arrangement; the actual element must match its housing and specified flow direction.
Conceptual cylindrical screen-element geometry. This is not a pressure-housing drawing or a fixed resin-trap flow arrangement; the actual element must match its housing and specified flow direction.Open the drawing at full size

Installation, inspection and cleaning

  • Confirm the flow direction, element seating and seals before service, then record the clean-element pressure difference at a known flow.
  • Investigate a rise in differential pressure or collected media. Cleaning the trap does not resolve the reason media escaped from the upstream unit.
  • Before opening the housing, isolate and depressurize the equipment using the site’s approved procedure.
  • Inspect for damaged slots, welds, corrosion and seal leakage. Clean by the agreed method and compare the pressure difference at a similar flow after reassembly.

Related filter equipment

Request a technical review

State whether an element or complete assembly is required. Include media grading, flow, fluid and temperature, slot requirement, housing and element drawings, connections, pressure conditions and monitoring requirements.