Industrial filtration and screening

Wedge wire rotary drum screen elements

Slotted cylindrical screening elements for rotary separation equipment. This page covers the drum screen component and its replacement fit, including the active surface, end rings, mounting and cleaning interface.

Flanged wedge wire rotary drum screen component

Operating principle and configuration

The screen separates liquid and retained solids as the drum rotates. In an internally fed arrangement, feed enters the drum, liquid passes through the wall and retained solids are conveyed toward discharge. Externally fed equipment uses a different flow and solids-removal arrangement; the working face and support orientation must follow the actual machine.

The drum element is one part of the system. Housing, drive, bearings, seals, spray equipment and solids discharge determine how the assembly operates. Changing the slot or active area must be reviewed with feed properties, rotation and cleaning rather than treated as a direct capacity upgrade.

Main technical specifications for selection

Feed and separationLiquid, solids concentration, particle grading, fibres, stickiness and required separation or recovery.
Flow arrangementInternal or external feed, direction through the screen, working face and location of retained-solids discharge.
Screen geometryInternal and external diameters, overall and active length, end rings, roundness and dimensional tolerances on the approved drawing.
Slots and supportsOpening and tolerance, wire orientation, support layout and any inactive bands or reinforced zones.
Mounting and rotationFlanges, bolt pattern, seats and drive interface; host speed, load and any specified runout or balance requirements.
Material and serviceFluid chemistry, temperature, abrasion and cleaning chemicals; specify compatible screen, ring and joint materials.
Cleaning interfaceSpray location, wash-water conditions, scraper contact or clearance where fitted, and access for inspection.
Replacement scopeScreen shell or complete drum component, retained host parts, drawing checks and agreed inspection before assembly.

Technical arrangement

Internal-feed concept: feed enters the drum, filtrate crosses the slotted wall and retained solids leave along the drum. External-feed machines use a different arrangement. This diagram explains flow paths; fabrication details follow the equipment drawing.
Internal-feed concept: feed enters the drum, filtrate crosses the slotted wall and retained solids leave along the drum. External-feed machines use a different arrangement. This diagram explains flow paths; fabrication details follow the equipment drawing.

Installation, inspection and cleaning

  • Inspect the host supports, seals and cleaning equipment when replacing a damaged drum; repeating the same screen geometry may not resolve a host fault.
  • Check mounting dimensions, roundness and the specified runout before commissioning. Verify free movement and required clearances.
  • Track plugging, uneven solids distribution and local wear. Inspect joints and end-ring regions during planned stops.
  • Use the cleaning method specified for the machine and screen material. Confirm spray coverage and avoid damaging the slot edges with unsuitable tools.

Related filter equipment

Request a technical review

Send a dimensioned drum drawing or sample measurements, photographs of both ends and the installed assembly, slot details, feed properties, operating speed and cleaning arrangement. State whether the request is for the screen component or a complete machine.